Follow these simple steps:

1. Light the smudge stick over an open flame. Rotate the stick back and forth slowly in the flame.

2. Once the smudge stick is successfully lit, let the stick burn for 30 seconds and lightly blow out the flame.

3. Set your players or intentions as you walk around the room. Let the smoke slowly flow away the negative energy. Depending on the size of the room or place, you may need to relight a few times to finish the ritual.

4. Once finished smudging the room, leave the smudge stick in a heat resistant container until it goes out on its own.

Follow these simple steps:

1. Cut the melt and pour soap base into 1 inch cubes.

2. Place the soap base chunks into a microwave-safe dish.

3. Microwave at 30 second intervals, stirring between each one, until they are all melted.

4. Add essential oils and coloring into the soap base and stir. (Optional: you may add decorative ingredients like dry flowers or exfoliative ingredients like poppy seeds, ground coffee or powder oatmeal).

5. Carefully pour the mixture into a soap mold.

6. Wait for the soap to cure (approximately 4 to 6 hours).

Follow these simple steps:

1. Use mortar and pestle to grind the resin into smaller pieces.

2. Use a heat resistant container and fill it up with sand. Light up a charcoal tablet until it smolders and carefully place it on the layer of sand.

3. Add a quarter teaspoon of resin to the charcoal. Do not add anymore resin until it’s completely burnt up, no more than a quarter teaspoon at a time.

Some brand of charcoal discs or tablets contain additives that may interrupt with the scent of the resin. If that is the case, you may place a small piece of aluminum foil between the charcoal and the resin.

Follow these simple steps:

1. Light the smudge stick over an open flame. Rotate the stick back and forth slowly in the flame.

2. Once the smudge stick creates a mini flame of its own, let the stick burn for 30 to 60 seconds.

3. Lightly blow out the flame. It will smolder and fill the room with an incredible aroma.

1. Place the rose of jericho in a shallow dish or bowl.

2. Add enough water to cover the roots. The plant will start to uncurl in about 4 hours and reach full capacity in a couple of days.

3. Change the water daily.

4. Do not leave in water for more than 7 days.

5. After 7 days, let the plant completely dry out. Can be used and revived several times.

Rose of jericho's natural habitat is in the desert. They thrive in dry weather and can survive with little water through dessication. For this reason, they are not used to be planted in water for long periods of time and will mold if let in water for more than 7 days.

It is recommended to let the rose of jericho dry out completely after one week and revive it when you are ready to see it flourish again.